Installation of Blinking Smart Stop

It’s very simple, it’s a Do-It-Yourself installation. It fits in the trunk using the labeled wires extending from the unit. The device comes with snap in line connectors for easy installation and fitting instructions.

The average install time is approximately 10-15 minutes.

Tools Required

Screwdriver, pliers/cutters

Difficulty rating scale 2 out of 10

Blinking Smart Stop Standard and Delay version - Blinking Smart Stop Plus version

I. Description

Applying your brakes will cause your existing third brake light to blink rapidly approximately 6 times, and then stay on solid as long as you have your foot on the brake pedal once you release the brake the unit then resets.

II. Features

· Size: 1" x 1" x 0.75" (25mm x 25mm x 19mm)

· Operating Voltage: 12 Volts DC

· Operating Temp: -30ºC to +70ºC

· Max Power Consumption: 1W

III. Circuit Diagram

Blinking Smart Stop Standard and Delay Version

IV. Installation

Locate access to the third brake light wires. The easiest access to them is from where you
change the existing bulb or LED bar.

Place a “Quick Connect” connector over positive (+) side wire going to the third brake light, and insert the Red wire. Using the pliers, squeeze the metal splice to secure the wires and then snap the cover closed.

Place a “Quick Connect” connector over the same positive (+) side wire going to the third brake light but between where you attached the Red wire and light.

Insert the Blue wire and squeeze and snap as before.

Place a “Quick Connect” connector over the negative (-) side wire (any chassis ground) and insert the black wire. Squeeze and snap as before.

Cut the positive (+) side wire between where you attached the Red and Blue wires from the Smart Stop.

Fit the Smart Stop inside somewhere away from areas of high temperature, moisture and water leakage...

Please note as the wiring in most vehicles vary because of the age of the vehicle. Please ensure the “Quick Connect” has a good connection i.e. ensure that the “Quick Connect” has cut through the wire insulation.

Blinking Smart Stop Plus Version

I. Description

Applying your brakes will cause your existing 2 main brake lights to blink rapidly, approximately 5 times and then stay on solid as long as you have your foot on the brake pedal. Works with all vehicles that have separate brake lights connections.

II. Features

· Size: 2" x 2" x 0.75" (25mm x 25mm x 19mm)

· Operating Voltage: 12 Volts DC

· Operating Temp: -30ºC to +70ºC

· Max Power Consumption: 1W